Check the exchange rates
West Country Welding Supplies

TT600 Positioner - West Country Welding Supplies, UK - West Country Welding Supplies, UK

TT600 Positioner

tt600The TT600 & TT1000 are the ideal solution for producing a circular weld, fast and accurately, or for accurately & rapidly positioning the work piece for welding etc.

Now fitted with high - low speed range switch

tt600-chuckOptional quick release self centre chuck
Comes with 2 types of jaws for internal or external clamping. The jaws will tighten onto any size from 5-210mm or will clamp internally into a pipe between 65mm & 210mm

The 345mm turntable can be positioned to any angle between horizontal & 90 degrees, a hand wheel which drives a worm gear is fitted at the rear to adjust this angle, a lock off device is fitted to prevent the table being accidentally moved or knocked off angle. The table is machined with 6 slots 90X12mm for mounting jigs or the chuck. The table is also scored every 30mm with a circle to assist in accurate setting up of the job. Under the table is a substantial brass bush arrangement for the welding earth return and we supply a 2M welding lead attached to this.
As standard the TT600 & TT1000 are supplied with a foot switch to stop & start the rotation. On the front panel there is a switch to select clockwise or anticlockwise rotation, a knob to control the speed & a high-low speed range switch for more accurate setting.
The TT1000 Precision is fitted with a double reduction gearbox to enable work at slower speeds.
All models are protected from HF interference.


Input Voltage: All 230VAC or 110V on request.
Max welding current: 350A @ 60%
Max load horizontal: 60KG
Max load vertical: 25KG
Rotation speed: 0.5 – 12 rpm
Dimensions: L= 430mm W=430mm, H=380


Remote socket for stop start to interface with a robot etc
Control to give automatic start and stop of rotation with the welding current.
Foot pedal to give stop start of the rotation with variable speed control on the pedal and start of the power source as well if required.
Timer control & an output to drive the power source, so only one control signal is needed to start the whole process.
Fully automated systems also built please enquire for further possibilities.

Back to top